3DR Single TTL MINI Radio Telemetry 433MHz 500mW for PIXHAWK and APM FC

With the help of this 3DR Radio Telemetry 433MHz 500mW Set, you may connect a flight controller to a computer, laptop, tablet, or other USB-capable device that has UART or USB connectivity (OTG).

The new V2 radios do not require an additional Air/Ground module because both transceivers support both modes and can be connected by USB or UART. In addition to displaying real-time data, the radio set allows you to view system voltage, heading, waypoint navigation, artificial horizon, and much more.

You can also fly your aircraft with a joystick via your computer and adjust settings in real time by using open source MAVlink based ground station software! Use it for your do-it-yourself projects that require a wireless Serial interface instead. This kit provides better performance, a greater range, and an amazing cheap price. The system makes use of HopeRF’s HM-TRP modules, which are powered by proprietary, open-source firmware, to enable a full-duplex connectivity over the 433MHz frequency.

Note:
When the term “APM” is used, it refers to the ArduPilot project, a group of free and open-source autopilots created by 3DR and the open-source community that are built on the Arduino platform. It’s based on an open source creative commons license and includes a selection of ArduPilot Mega (APM) electronics and several free software versions for various vehicles.

Important Reminder: Make sure the antenna is attached before turning on the 3DR telemetry.
Note: There may be a case option for this product.

Features: 

• Status documents are framed by the MAV Link protocol.
• Spread spectrum and frequency modulation (FHSS)
• Self-adjusting to multiplexing of time division
• Encourage LBT and AFA
• Duty cycle that can be adjusted
• Error correction code built in (up to 25% data bit error)
• Configure data transport using AT command
• Data transmission using remote control commands
• Swapable 433MHz air and ground modules
• Micro-USB port 6-position Molex connector with a configurable maximum output power of 250mW
• SMA connector adaptable TDM UART interface for two-way full-duplex communication
• Clear serial connection
• SIK firmware that is available for free
• Configurable using *APM Planner and *Mission Planner
• based on the HM-TRP wireless module, with a Si4432 and a Si1000 8051 microprocessor