433Mhz 100mW Radio Telemetry Kit

Based on the 3DR Telemetry kit, this 433MHz 100mW Radio Telemetry V2 Kit is 100% compatible because it uses the same onboard firmware. Naturally, we at Unmanned Tech are allowed to use this 3D Robotics firmware on our own version because it is entirely open-source.

With the help of the Unmanned Telemetry Kit, you can quickly add a two-way telemetry link between your drone and ground station, working with both Ardupilot and Pixhawk-based systems. We are so confident in the performance and dependability of this product that we are offering our complete support and warranty with it.

This is the updated and upgraded Unmanned Telemetry kit, version V2. The key characteristics are that the ground and air modules are now interchangeable and that each has a USB and a DF13 connector. The complete list of features and specifications is provided below. Please take note that in order to connect to Pixhawk, it is recommended to buy an additional 6-pos to 6-pos connection since this is a more convenient and superior option than using the provided wire.

Note: The product comes in two variations: one with a case, and the other is random.
Only control boards that are APM compliant can be used with this telemetry.

We will ship the connecting cable to our customers at random because there are some colour variations.

Features:

very compact and light (less than 4 grams without an antenna).
Clear serial connection
Framing of the MAVLink protocol and status reporting
Spread spectrum using frequency hopping (FHSS)
Time division multiplexing (TDM) that is adaptive
In favour of LBT and AFA
Duty cycle that can be adjusted
Changeable ground and air modules
Six-position DF13 connection micro-USB port

Maximum output power of 100 mW (adjustable)
based on the HM-TRP module and RP-SMA connector from HopeRF

Fully duplex two-way communication using an adaptive TDM UART interface
Clear serial connection
Framing of MAVLink protocol
Spread Spectrum with Frequency Hopping (FHSS)
Duty cycle that can be adjusted
Up to 25% of bit mistakes are corrected with error correction.
Configurable using APM Planner and Mission Planner
Integrated error-correcting coding that can fix data bit mistakes up to 25%
the several-kilometer range that a tiny Omni antenna has been shown to have
can extend its range even farther by using a bi-directional amplifier.
AT instructions to set up the radio
RT instructions for configuring a remote radio
Adaptive flow management in conjunction with APM
built around the SiLabs Si1000 RF microcontroller and based on the HopeRF HM-TRP radio module.