Digispark ATTINY85 Mini USB Development Board

Despite being little in size, having enormous power. Although it is smaller and less expensive than the Arduino, the Digispark ATTINY85 Mini USB Development Board is still somewhat less powerful. This board is an excellent starting point for microcontroller electronics since it can be customized with a wide range of shields to increase its capabilities and it can be used with the well-known Arduino IDE.

Entire USB Development Board: Reasonably priced to be included in a project. It could take you a while to realize the full potential and strength of the Digispark ATtiny board if you have never heard of it.Thus, carefully read this:

First off, it’s an AVR 8-bit, 20MHz microcontroller with 512 bytes of RAM and 8 KB of flash.

A maximum of 5 GPIOs, 4 ADCs, 2 PWMs, 1 SPI, and 1 I2C are included[*].

Second, it works flawlessly with Arduino.

Thirdly, no additional programmer is required as it can be immediately programmed over USB!

Finally, it can be purchased for a reasonable price!

With the exception of the two readily solderable headers that are included, the Digispark is shipped completely constructed.

Features :

1. High Performance, Low Power AVR® 8-Bit Microcontroller
2. Non-volatile Program and Data Memories
3. 8K Bytes of In-System Programmable Program Memory Flash
4. Endurance: 10,000 Write/Erase Cycles
5. 512 Bytes In-System Programmable EEPROM
6. 512 Bytes Internal SRAM
7. Peripheral Features
8. Two High-Frequency PWM Outputs with Separate Output Compare Registers
9. USI – Universal Serial Interface (12C, SPI, 1-wire) with Start Condition Detector
10. 10-bit ADC
11. 4 Single Ended Channels
12. Two Differential ADC Channel Pairs with Programmable Gain (1x, 20x)
13. Speed Grade
14. 0 – 10 MHz @ 2.7 – 5.5V, 0 – 20 MHz @ 4.5 – 5.5V
15. Industrial Temperature Range
16. Low Power Consumption
17. Active Mode:1 MHz, 1.8V: 300 µA