TB6560 Driver Board 3A CNC Router Single 1 Axis Controller Stepper Motor

The TB6560 Single 1 Axis Controller Driver Board 3A CNC Router With a wide heat sink to provide adequate heat dissipation, the stepper motor driver board is used for axis control and has high-speed optocoupler isolation in the input signal. With a range of semi-flow model and semi-flow current setting functions, the stepper motor driver is semi-flow mode and semi-flow current changeable.

There are no additional instructions needed to use the TB6560 Driver Board 3A CNC Router Single 1 Axis Controller Stepper Motor; it is very simple to use. The module offers a range of semi-flow models and semi-flow current setting functions, with changeable semi-flow mode and semi-flow current—not the typical design found on the market.

The TB6560AHQ new original chip is featured in this TB6560 Driver Board 3A CNC Router Single 1 Axis Controller Stepper Motor driver. To guarantee peak performance, the TB6560AHQ incorporates an overcurrent protection circuit, low voltage shutdown, and overheating stop.

The most widely used current circuit, the TB6560 stepper motor control circuit, has a maximum output of 3A and can operate a two-phase motor (10–35VDC). Stepper motor control, CNC machine applications, and precision mechanical systems are applications for the TB6560 stepper motor control circuit.

Features:

• Current level can be changed to accommodate different application needs.
• semi-automatic, adjustable flow.
• Employing the high-speed optical coupler 6N137 to guarantee rapid speed.
• Setup instructions displayed on the board.
• Good heat dissipation using a thick, finely-toothed radiator.
• Not suitable for stepper motors greater than 3A. For 42,57,86 steppers within 3A 2/4-phase / 4 wire / 6 wire.
• Excitation Mode: up to 16 segments, half step, 1/8 step, and 1/16 step synchronisation.
• Automated partial decay.