KY-005 38KHz Infrared IR Transmitter Sensor Module ₹49.00
Back to products
DIY D2-1 Intelligent Line Follower/Tracing Car Kit ₹249.00
-18%
Click to enlarge

DIY D2-5 Intelligent Tracking Line Car Kit

  • Easy to Assemble
  • Operating Voltage: 3V
SKU: 710177

IBOTS's 10th Anniversary Sale

Hurry and get discounts on all Raspberry Products up to 20%

IBOTS1000

₹499.00

Compare
Add to wishlist
  • Pick up from the IBOTS Store

Free

  • Delivery Charges: Tamil Nadu

₹75 for parcels below 1 Kg and ₹100 for parcels weighing between 1 Kg to 2 Kg.

2-3 Days

₹75

  • Delivery Charges: Other South India

₹125 for parcels below 1 Kg and ₹175 for parcels weighing between 1 Kg to 2 Kg.

2-3 Days

₹125

  • Delivery Charges: North India

₹250 for parcels below 1 Kg and ₹325 for parcels weighing between 1 Kg to 2 Kg.

2-3 Days

₹250

  • Courier delivery

Our courier will deliver to the specified address

2-3 Days

Rs. 99

  • Warranty 1 year

More details

  • Free Returns Policy

More details

Payment Methods:

1. Order the Product and Specify the Delivery Method

2. You Will Receive an Order Confirmation Message

3. Wait for Your Order to Arrive

4. Pick up Your Order at The Checkout Area

Description

  • Install the four gaskets on the circuit board.
    The role of the gasket is to increase the gap between the axle and the circuit board, so that the gear mounted on the shaft has enough rotation space.
  • First insert a M2.2 * 8 screw from the front of the board into the mounting hole, place a gasket from the back of the circuit board on the screw.
  • Clamp the gasket with a small pliers, turn the screw with a small screwdriver until the gasket is close to the circuit board at last.
  • Insert a steel shaft from the center hole of the wheel and note that the direction is inserted from one side of the raised sleeve of the wheel. It is better to insert the steel shaft parallel to the smooth side of the wheel.
  • Put a three-way sleeve into the steel shaft, close to the wheel, and then a gasket into the steel shaft, close to the three-way sleeve, installed in place, toggle three-way sleeve, should be flexible. Otherwise appropriate to increase the gap between them.Install tires.
  • Place a gear into the steel shaft in the center of the steel shaft.
  • Put a three-axis sleeve into the end of the steel shaft so that the car side of the wheel assembly to complete.
  • Holding the wheel by hand, keep the steel shaft level, adjust the position of the three-way sleeve on the end of the steel shaft. The gears on the steel shaft should fall into the gear slot, otherwise the gear position should be adjusted until it meets the requirements.
  • Finally, the two shafts on the steel shaft are fitted into the screw projections of the fixed washers and tightened with a small screwdriver so that the wheel assembly is installed. Install the other side of the wheel assembly in the same way.
  • Install Motor Insert a worm into the motor shaft,Then thought worm from the front of the circuit board to others.Use two small screws to hold the motor.Pay attention to the direction of motor. Contact motor and PCB by cable. It can reversed the wire of motor if motor move on the contrary when power on.

Customer Reviews

0 reviews
0
0
0
0
0

Reviews

Clear filters

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.