Showing 1381–1392 of 4073 results
Shop
Digispark ATTINY85 Mini USB Development Board
- High Performance, Low Power AVR® 8-Bit Microcontroller
- Non-volatile Program and Data Memories
- 512 Bytes In-System Programmable EEPROM
- 512 Bytes Internal SRAM
- USI – Universal Serial Interface (12C, SPI, 1-wire) with Start Condition Detector
- 10-bit ADC
- 4 Single Ended Channels
- Two Differential ADC Channel Pairs with Programmable Gain (1x, 20x)
- Low Power Consumption
- Active Mode:1 MHz, 1.8V: 300 µA
Digital Display for HC-SR04 Ultrasonic Distance Measurement Control Board
- High-performance STM8S103 microprocessor onboard with digital tube display and valid measurement 3-400 cm is the distance.
- Unit of Display: cm
- 2.54mm White Socket: 5V power interface; Maximum Input Voltage: 5VDC.
Digital LDR Module – 4Pin
- LDR module 4 PIN
- Operating voltage 3.3V-5V
- Signal output indicator light.
Digital Multi Servo Tester ESC RC Consistency CCPM Master Speed Control
- Operating Voltage: DC 4.8-6V
- Offer 3 modes to check servos or ESC
- The Manual Mode allows you to turn the knob to different speeds and check the reaction time
- The Neutral mode makes the servo go back to the neutral point
- The Automatic ’’Window Wiper’’ Mode makes the servo swing like a window wiper in the largest angle possible
- Connect to up to 3 servos simultaneously
Digital Multimeter Small Yellow Color LCD AC DC Measuring Voltage Current
- Dimensions (LxWxH): 12.5 x 7 x 2 cm
- Probe Length: around 2 feet (60 cm)
- Weight: 160 grammes
- Shade: Yellow
- LCD 15 millimetres high.
Digital Temperature Module For Arduino AVR PIC DIY Maker
- Power supply: 3 – 5V
- Good sensitivity
- The output format: Digital switching output (0 and 1)
- The comparator output signal is clean, good waveform, driving ability, more than 15mA.
- A fixed bolt holes for easy installation.
- Using a wide voltage LM393 comparator.
DIGITAL VOLTAGE CAPACITY METER
The “EV Digital Voltage Capacity Meter” is a device used to measure and display the voltage and capacity of electric vehicle (EV) batteries. Here’s a concise description:
“The EV Digital Voltage Capacity Meter is a compact device designed to accurately measure and display the voltage and capacity of electric vehicle batteries. With its digital interface, it provides real-time information, allowing users to monitor the state of their EV batteries conveniently.”
Digital Voltmeter (0-100V) and Ammeter (10 A) Dual Led Voltage Current Measurement Module
Input Voltage – 4.5V to 30V DC
Input Current – <= 20mA
Display Color – Red (Voltage) , Blue (Current)
Measuring Voltage Range – 0V to 100V DC
Measuring Currrent Range – 0A to 10A
Measurement Accuracy – 1%
Minimum Voltage Resolution – 0.1V
Minimum Current Resolution – 0.01A
Size – 48x29x21mm
DIP 3 Color LED Module
- The use of plug-in full-color LED.
- RGB trichromatic limiting resistor to prevent burnout.
- Through the PWM adjusting, three primary colors can be mixed to obtain different colors.
- With a variety of single-chip interface.
- The working voltage: 5V.
- LED drive mode: common cathode driver
Direct V6 Short Distance 1.75 3D Hotend Heatsink
- Adaptable to nozzles of various diameters
- Simple to set up and operate
- High-Temperature Operation
- Inner diameter: 4.7 mm (End-2) and about 1.6 mm (End-1).
Disc brake pad for Rear wheel
- Heavy duty Brake Pad
- High strength
- Coated with long life material
- for OLA electric scooter
DISPLAY METER WITH EXTRA BODY MOUNT CLAMP 48V/60V
A “display meter with extra body mount clamp 48V/60V” likely refers to a component used in electric bicycles or scooters for displaying information such as speed, battery level, distance traveled, and possibly other metrics related to the vehicle’s operation.