Showing 613–624 of 4075 results
Shop
5A Constant Current / Voltage LED Drives Lithium Battery Charging Module
- Input Voltage Range: 4-38V
- Output Voltage Range: 25-36V continuously adjustable
- Output current: adjustable, up to 5A
- Output power: up to 75W
- Working temperature :-40 ~ + 85 degrees
- Working frequency: 180KHz
5A range Current Sensor Module ACS712
- Low-noise analog signal path.
- Device bandwidth is set via the new FILTER pin.
- 5 µs output rise time in response to step input current.
- Small footprint, low-profile SOIC8 package.
- 2.1 kV RMS minimum isolation voltage from pins 1-4 to pins 5-8.
5A Single Phase AC Current Sensor Module
Features
- Onboard precision microcurrent transformer.
- Onboard sampling resistor.
- The module can measure AC currents less than 5A, the corresponding analog output 5A/5mA.
5inch HDMI LCD (B) – 800×480 – Resistive Touch
- Size: 5″
- Resolution: 800×480
- Display Port:Â HDMI
- Resistive touch control.
- Support backlight control, more power saving.
5M Neon Light Dance Party Decor Light Neon LED Lamp Flexible EL Wire Rope Tube Waterproof LED Strip – Only EL Wire -BLUE
- Can offer 360 degrees of illumination
- Energy-saving, long lifetime
- Wire diameter:Â 2 mm
- EL light length: 5M
- Lifetime: >12,000 hours
- Color: Blue
5mm LDR (Pack of 10)
- 5 mm in diameter
- Two pins in total.
- Mounting Type: PCB Through Hole
- The maximum operating temperature is around +800°C.
- Resistance to dark: 1–20 M ohm
5mm Two-Color LED Module
- Operating Voltage:2.0v ~ 2.5v
- Current:10mA
- Diameter:5mm
- Color:Red +Â Green
- Beam Angle:150
5MP Raspberry Pi Zero W Camera Module W/ HBV FFC Cable
Features :
- Supported Video Formats: 1080p @ 30fps, 720p @ 60fps and 640x480p 60/90 video
-
Fully Compatible with Raspberry Pi Zero W.
-
Directly plug into Raspberry Pi Board (besides HDMI port)
- Small and lightweight camera module.
- Plug-n-Play camera for Raspberry Pi Zero W.
Package Includes :
5MP Rpi 3/4 B camera module with cable
- Resolution: 5 MP
- Interface Type: CSI(Camera Serial Interface)
- Dimensions: 25x23x8 (LxWxH) mm
- Supported Video Formats: 1080p @ 30fps, 720p @ 60fps and 640x480p 60/90 video
- Fully Compatible with Raspberry Pi 3 and 4 Model B
- Plug-n-Play camera for Raspberry Pi 3 and 4 Model B.
5PIN RMC WIRE (FEMALE TO FEMALE) -30CM
5S 15A 18650 Li-ion Lithium Battery BMS Charger Protection Board for 18V 21V Battery
- Voltage used for charging: 21V
- 56 A is the charging current.
- Current for continuous discharge: 15 A
- 50/55/60 A overcurrent protection
- Delay in overcurrent protection: 20/25/30 mS
- Power consumption for a single part since: 30 uA
- Voltage range for single section discharge detection: 2.75–2.85V
- Voltage range for over discharge recovery: 2.90–3.20V
5V 0.2A 3007 Cooling Fan for Raspberry Pi and 3D Printer
- Ideally suited for the extruder
- Silent Performance
- Extremely low usage of current
- Simple to connect to and install.
Load more products
Loading...







Motors